| Online Skill Training > Online Module > Windsor Probe Test System | |
|
|
|
|
| | Introduction | Step 1 | Step 2 | Step 3 | Step 4 | Step 5 | Step 6 | |
 |
Driving Probes on flat surfaces. Place triangular template on the concrete, depress the driver unit over one of the circular bosses until it bottoms out, hold driver firmly, check to be sure driver is at right angles to template, and pull the trigger. Reload and repeat until one probe has been set in each of the three bosses. |
 |
Removing Power Load Casing. To remove the casing of an expended power load from the breech plug, simply remove the breech plug and set it over the extrator post. |
 |
Driving Probes on curved surfaces. Use the single probe-locating template, place on concrete and drive three probes individually. |
|
|